DSMS Stepper Motor and Integrated Microstepping Drive
The DSMS motor is ideally suited for machine designers who want the simplicity of an integrated solution. The DSMS motors reduce
the wiring in the system and the potential for problems due to electrical noise.
Advanced second generation current control for exceptional performance and smoothness.
Low cost, high performance motion control solution.
Reduce system cost, design and machine assembly time.
Operating voltage +12 to +48 VDC for NEMA 17 frame or +24 to +75 VDC for NEMA 23/34 frames.
Available in three motor lengths and three frame sizes.
Torque from 22 to 749 N-cm.
20 resolution settings from 400-51200 steps/rev.
USB programming cable for easy setup.
Windows interface for quick and easy parameter setup.
The DSMS motor is available with a factory-mounted knob for manual shaft positioning.
|Choice of connectors
The flying lead option brings out all stepper control signals and power to 300 mm (12 in) flying leads.
The P-connector option brings all connections out to spring clips. Wires connect directly to motor. Not available on 34-frame size motor.
Sydney Tel: (02) 9674 5455 • 1300 BALDOR • Melbourne Tel: (03) 9753 4355